Part Number BE093
Definition
The Model TEC is a self-contained system for removing moisture from a sample gas stream. All wetted parts are made of 316 stainless steel, so it is suitable for hot, corrosive gases. The gas flow pattern uses proprietary vortex heat-shedding. It is compact and rugged. Its maximum power heat transfer is 150 Watts, so it may be used at relatively high flow rate. Condensed water is pumped out below. The unit is powered by 110 or 220 Vac. A microprocessor controller monitors all aspects of performance.
The Model TEC is a self-contained system for removing moisture from a sample gas stream. All wetted parts are made of 316 stainless steel, so it is suitable for hot, corrosive gases. The gas flow pattern uses proprietary vortex heat-shedding. It is compact and rugged. Its maximum power heat transfer is 150 Watts, so it may be used at relatively high flow rate. Condensed water is pumped out below. The unit is powered by 110 or 220 Vac. A microprocessor controller monitors all aspects of performance.
Features
1. Compact design fits into small spaces.
1. Compact design fits into small spaces.
2. Solid state. No compressor or other mechanical
parts to fail.
3. All wetted parts are
SS-316. Proprietary vortex heat-shedding design.
4. PID temperature controller included. This also
includes signal output for external monitoring.
Basic Specifications
Flow rate: 0 – 8 slpm
Gas temperature range: 100 – 500 °F (38 – 260 °C)
Maximum power heat transfer: 150W
Flow rate: 0 – 8 slpm
Gas temperature range: 100 – 500 °F (38 – 260 °C)
Maximum power heat transfer: 150W
Copyright © 2010, Black Oak Engineering - Basic Instruments, LLC (BOE). All rights reserved. BOE reserves the right to make changes to these specifications as it deems necessary. All technical information contained herein is as accurate as possible; however, BOE shall not be held responsible for its use, nor for any infringements upon the rights of others which may result from its use. BOE products are not to be used in life support applications. All costs given herein are purely budgetary and are subject to change. Contact us for a quotation.
Warranty Policy. Any instrument ordered from BOE may be returned for full refund, less shipping costs, within 30 calendar days of delivery, provided that the instrument has not, in the opinion of BOE, been damaged or misused. An RMA number is required in all cases. See our Standard Terms & Conditions.
Basic Instruments are designed and manufactured in the USA, and they comply with ISO9001:2000.
Office 263 • 1002 Lititz Pike • Lititz, PA, USA 17543